20
Sun Fire V445 Server Installation Guide • November 2006
Installing the Cable Management Arm
This procedure describes how to attach the cable management arm to a server that
is already installed in a cabinet.
You need the following components from the ship kit and the rackmounting kit to
install the cable management arm and to connect the cords and cables:
■
Cable management arm
■
Ethernet (RJ-45) cable
You also need four AC power cords, which are supplied separately.
FIGURE 2-11
Cable management arm and system cables
1. Loosen the four screws that secure the system to the left and right vertical rails at
the front of the cabinet.
2. Slide the server smoothly out of the cabinet about 3 inches (7.62 cm).
Sliding the server out of the cabinet enables easy access to the areas where you will
attach the cable management arm.
(Not supplied in kit)
AC power cords (4)
Ethernet RJ-45 cable
Cable management arm
