Sun StorEdge N8200 Filer Installation, Configuration, and Service Guide
13
4. Provide the following information as the system prompts you to set up the initial
configuration.
a. Choose a language. [0 = English]
0
b. Choose a locale. [0 = USA (ASCII)]
0
c. Choose a terminal type.
[3 = DEC VT100, 12 = XTERM]
3 or 12
d. Type the host name.
_______________________, F2
e. Specify whether you have network connectivity. [Yes/No]
F2 (Yes)
f. Give the IP address.
_______________________, F2
g. Confirm the above information. [Yes/No]
F2 (Yes)
h. Name the service. [NIS, DNS, or none]
_______________________, F2
If NIS or DNS, consult your network
administrator to provide:
■
The domain name
_______________________, F2
■
The controller name
_______________________, F2
i. Confirm the name service information. [Yes/No]
F2 (Yes)
j. Is the system part of a subnet? [Yes/No]
F2 (Yes)
k. Type the netmask.
_______________________, F2
l. Confirm the time.
■
Region
_______________________, F2
■
Time zone
_______________________, F2
■
Date and time
_______________________, F2
■
Confirm information
_______________________, F2
m. Type and verify the root password.
____________________, Enter
Note –
Make a copy of these settings and store it in a safe place for future reference
and disaster recovery.
5. Wait while the system automatically reboots; it will take approximately two to
three minutes.
When the login prompt appears, indicating the system has successfully booted,
disconnect the serial cable from the controller serial port A and the console.
