Sun Microsystems StorEdge MultiPack-FC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 47 / 84

Chapter 2 Operation 2-13
2.7.2
probe-scsi-all
At the
ok
prompt, use the
probe-scsi-all
command to verify that a host system’s
Fibre Channel Arbitrated Loop (FC-AL) controller recognizes externally connected
Fibre Channel hard drives.
Note –
The
probe-scsi-all
command does not function identically on all
platforms and does not in all cases probe for Fibre Channel devices. In such an
instance, see Section 2.7.3 “
show-devs
and
show-children
.”
The
probe-fcal-all
command exists only on Sun Enterprise™ systems.
2.7.3
show-devs
and
show-children
At the
ok
prompt, the
show-devs
and
show-children
commands are used as
shown in FIGURE 2-9 and FIGURE 2-10.
FIGURE 2-9 is continued sequentially in FIGURE 2-10.
ok probe-scsi-all
/pci@8,600000/scsi@4
Li D HA --- Port WWN --- ---- Disk description ----
1 1 210000203700ca6d SEAGATE ST39103FCSUN9.0G01479916015471
8 8 210000000ec90dac FUJITSU MAG3182F SUN18G 08129921B01224
a a 210000000ec91003 FUJITSU MAG3182F SUN18G 08129922B01729
b b 210000000ec90b48 FUJITSU MAG3182F SUN18G 08129922B01014
9 9 210000000ec90db8 FUJITSU MAG3182F SUN18G 08129922B01257
c c 210000203718b13d SEAGATE ST318203FSUN18G 034A9933260868
d d 210000203718ac99 SEAGATE ST318203FSUN18G 034A9933259826
10 10 210000000ec90dac FUJITSU MAG3182F SUN18G 08129921B01224
12 12 210000000ec91003 FUJITSU MAG3182F SUN18G 08129922B01729
13 13 210000000ec90b48 FUJITSU MAG3182F SUN18G 08129922B01014
11 11 210000000ec90db8 FUJITSU MAG3182F SUN18G 08129922B01257
14 14 210000203718b13d SEAGATE ST318203FSUN18G 034A
15 15 210000203718ac99 SEAGATE ST318203FSUN18G 034A
/pci@8,700000/scsi@6,1
Target 0
Unit 0 Disk SEAGATE ST39173W SUN9.0G2815