Sun Microsystems StorEdge MultiPack-FC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 42 / 84

2-8 Sun StorEdge MultiPack-FC Installation, Operation, and Service Manual • August 2000
2.4 Powering On and Off
This section describes how to turn on and off the power to your Sun StorEdge
MultiPack-FC unit when it is connected to a desktop host.
FIGURE 2-6
Power Switch and Inlet Locations on the MultiPack-FC
2.4.1 Powering On the System
Caution – Perform the appropriate procedure in Section 2.3 “Setting the Box ID” on
pages 2-6 and 2-7 before performing the following power-on procedure.
1. Turn on the power to the data storage peripheral devices connected to the host in
this order:
a. Last device on the daisy chain
b. Other peripheral devices
2. Turn on the power to the monitor.
3. Turn on the power to the host.
Caution – Always allow 10 seconds between turning off the power and turning it
back on again. This prevents possible damage to the power supply assembly
components in your system.
AC power on/off switch
AC power inlet
0
|