Sun Microsystems StorEdge D2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 54 / 118

3-4 Sun StorEdge D2 Array Installation, Operation, and Service Manual • February 2002
3.3 Task Overview for Monitoring the
Health of the Array
TABLE 3-1
Tasks for Monitoring the Health of the Array
Task Where Documented/Notes
Look for evidence of a disk failure in log files. • Refer to the documentation that comes with
the disk to find out where the device driver
logs errors.
• Also search for messages about disk failures in
/var/adm/messages
.
Invoke the SunVTS enctest (enclosure test) at any time to
test the health of the enclosure (if you are using a version
of SunVTS with D2 enctest support). You can run SunVTS in either a CDE or an
OpenWindows GUI or on the command line. See
the
SunVTS Test Reference Manual for how to
access the enctest dialog box in the GUI and for
command line options. See the
SunVTS User’s
Guide for other information.
Use the Identify function of Network Storage Agent to
cause the Subsystem LED to blink on the array where a
problem is located. See “Locate the Unit ID on the map created in
Step 8 on page 4.” on page 3-14.
Set up Network Storage Agent software periodically poll
the enclosure and to send notifications of problems to
your system administrator or to Sun’s Network Storage
Command Center (NSCC). See the Network Storage Agent documents listed
in “Before You Read This Book” on page xii.