Sun Microsystems STOREDGE A5000, Инструкция по установке и обслуживанию

Страница: 80 / 146

7-4 Sun StorEdge A5000 Installation and Service Manual • September 1999
3. Use the
luxadm remove_device
command to remove the disk from the FC-AL
loop.
This command is interactive and will prompt you to physically remove the disk. For
example:
Note –
Do not hit Return until Step 4 and Step 5 have been completed.
The
luxadm remove_device
command also accepts box name and drive location.
For example:
Note –
If the l
uxadm remove_device
fails to remove the disk, use of the
luxadm
remove_device -F
option (for example,
luxadm remove_device -F box2,r0
)
may be required. Make sure you have stopped all I/O to the disk drive before using
the
-F
option. Refer to the
luxadm
man page for more information.
#luxadm remove_device /dev/rdsk/c0t48d0s2
WARNING!!! Please ensure that no filesystems are mounted on these
device(s).
All data on these devices should have been backed up.
The list of devices which will be removed is:
1: Box Name "box2" rear slot 0
Please enter 'q' to Quit or <Return> to Continue:
stopping: Drive in "box2" rear slot 0....Done
offlining: Drive in "box2" rear slot 0....Done
Hit <Return> after removing the device(s).
# luxadm remove_device box2,r0