Sun Microsystems STOREDGE A5000, Инструкция по установке и обслуживанию

Страница: 133 / 146

Appendix D Firmware and Device Driver Error Messages D-7
The above message occurs when the
SF_MAX_LILP_ENTRIES
variable is exceeded.
It indicates that there are too many nodes on the loop for it to successfully complete
initialization. When this occurs, the disk array associated with this message will not
be functional.
The above message is displayed when the target/al_pa address does not match the
hard address of the device. This can be caused by disks being removed and
reinserted into the wrong slot of a disk array.
The above messages are the result of an attempt to add a new device to an existing
loop when a pre-existing device with the same ID already exists. When this error
occurs, the device associated with this messages will not be functional.
The above message is displayed if the
sf
driver senses that the WWN of a node is
not the same as what it expects to find at the indicated target. When this error
occurs, the device associated with this message will not be functional.
The above message is displayed if the
sf
driver attempts to create a device that is
not either an
ses
or
ssd
device. When this error occurs, the device associated with
this message will not be functional.
sf #: invalid lilp map
sf #: target 0x%x, AL-PA 0x%x and hard address 0x%x don’t match
sf #: target 0x%x, duplicate port wwns sf #: target 0x%x, duplicate
switch settings
sf #: wwn changed on target 0x%x
sf #: target 0x%x, unknown device type