Sun Microsystems StorEdge 6120, Руководство пользователя

Страница: 26 / 50

19. (Optional) Return the resource groups and device groups that you identified in
Step 1 to the original nodes.
# scswitch -z -g
resource-group
-h
nodename
# scswitch -z -D
device-group-name
-h
nodename
For more information, see your Sun Cluster system administration documentation.
20. Perform volume management administration to incorporate the new logical
volumes into the cluster.
For more information, see your Solstice DiskSuite/Solaris Volume Manager or
VERITAS Volume Manager documentation.
How to Add a Dual-Controller Configuration to an
Existing Cluster
Use this procedure to add a dual-controller configuration to a running cluster. The
following procedures contain instructions for other array-installation situations:
■ “How to Install a Single-Controller Configuration in a New Cluster” on page 17
■ “How to Install a Dual-Controller Configuration in a New Cluster” on page 19
■
“How to Add a Single-Controller Configuration to an Existing Cluster” on page 22
This procedure defines
Node N
as the node with which you begin working.
▼
How to Perform Initial Configuration Tasks on the Storage
Array
1. Power on the storage arrays.
Note –
The storage arrays might require several minutes to boot.
For the procedure about how to power on storage arrays, see the Sun StorEdge 6120
Array Installation Guide .
2. Administer the storage array’s network settings. Network settings include the
following settings.
■ IP address
■
gateway (if necessary)
■
netmask (if necessary)
■ hostname
Steps
26 Sun Cluster 3.0-3.1 With Sun StorEdge 6120 Array Manual for Solaris OS • January 2006, Revision A