Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 211 / 318

Appendix A Sun StorEdge 3510 FC Array Specifications A-3
A.2 Sun StorEdge 3510 FC Array Highlights
The following topics briefly describe specific hardware and firmware features.
A.2.1 Hardware Loop ID
Each device communicating on an arbitrated loop requires an AL_PA, the Arbitrated
Loop Physical Address. The host Fibre Channel supports a single hard loop ID in the
range from 0 to 125. The drive channel allows up to 125 devices to be connected to a
single loop.
The controller supports automatic loop ID assignment on the drive channel. A hard
loop address ID is assigned to the disk drives by setting the radial switch.
Feature Description
General • Up to 12 hot-pluggable drives in a 2U (3.45 in. / 8.76 cm high) chassis
• Autosensing AC or DC power supplies
• Dual-host access in certain configurations
Density • Up to 876 GB in a RAID array (with 73 GB drives)
• 21 in. chassis depth
• RAID supports up to two expansion units
Reliability • Redundant hot-swappable FRUs
• Single or redundant active/active hot-swappable RAID controllers
• N+1 hot-swappable power and cooling
• NEBS Level 3 and HALT test certified; designed to meet 99.999% reliability
RAID System
Storage Resource
Management • Web-based 10/100BASE-T Ethernet support
• Serial port out-of-band support with modem control
• RAID Levels 0, 1, 1+0, 3, 3+0, 5, and 5+0
• Up to 1024 LUNs
• SNMP traps and MIB in firmware
• 1-GB cache memory standard
• Four channels are user-configurable as drive or host channels; two channels are
dedicated drive channels
• Support for Sun StorEdge Configuration Service and Diagnostic Reporter
management software