Sun Microsystems StorageTek T10000, Руководство оператора

Страница: 66 / 120

View/Change Configuration Settings
64 T10000 Operator’s Guide • July 2008 Revision EA • 96174
Port A/B Custom/Normal WWN Submenu
Note : This submenu only appears if a Custom WWN is in use, or is being created/edited.
WWN Custom Appears whenever a Custom WWN is in
use, or is being created/edited.
WWN Custom
also appears when the drive
is using dynamic WWN, set by a library
invoking dWWN.
1. Do one of the following:
■
Press Menu to bypass to the next
submenu.
■
Press Select to toggle the selection to
WWN Normal
WWN Normal Selection recalls the stored Normal WWN
from the drive EEPROM. 2. Do one of the following:
■
Press Menu to recall the stored Normal
WWN, and advance to the next
submenu.
■
Press Select to toggle the selection to
WWN Custom
.
Port B Attributes Menu
View PrtB ?
(online)
Cfg PrtB ?
(offline)
View or change Port B attributes as defined
in the preceding port A/B attributes
submenus, starting on
page 61 .
Do one of the following:
■
Press Menu to bypass
■
Press Select to enter the port
attributes submenus.
Emulation Mode Submenu (FC P)
Emul XXXXX Emul STD is Native.
Emul 9840
Emul 9940
Emul 3592
Do one of the following:
■
Press
Menu
to bypass
■
Press Select until desired option
appears; then, press
Menu
to set, and
advance to the next submenu.
Note : Manufacturing ships Fibre Channel (FCP) drives with the Emul STD option selected.
Emul 9840 and Emul 9940 are special modes used only at the direction of Sun StorageTek Support.
When using VOP to change Emulation mode, you must have VOP version 1.0.9, or higher.
Otherwise, the current mode option cannot be changed by VOP.
Emulation Mode Submenu (FICON)
Emul XXXX
Emul 3592
Emul VSM
Do one of the following:
■
Press
Menu
to bypass
■
Press Select to toggle; then, press
Menu
to set, and advance to the next
submenu.
Note : Manufacturing ships FICON drives with the Emul 3592 option selected.
Change the selection to Emul VSM as needed to match site requirements.
When using VOP to change Emulation mode, you must have VOP version 1.0.9, or higher.
Otherwise, the current mode option cannot be changed by VOP.
TABLE 4-1
Drive Configuration Settings (Continued)
Options Notes Procedure