Sun Microsystems StorageTek SG-XPCIE1FC-QF8-Z, Руководство по установке

Страница: 40 / 68

30 Sun StorageTek 8 Gb FC PCI-Express HBA Installation Guide • September 2009
3. For Red Hat Linux users, edit the
/etc/modprobe.conf
file and add the
following entries, if they are not present:
■
alias scsi_hostadapter1 qla2xxx_conf
(for use only with SANsurfer)
■
alias scsi_hostadapter2 qla2xxx
4. For SUSE Linux users, edit the
/etc/sysconfig/kernel
file and modify the
INITRD_MODULES
directive as shown in the following example.
In this example, note that you must add the first module,
qla2xxx_conf
(for
SANsurfer), followed by the
qla2xxx
module. The
qla2xxx_conf
module is for
use only with SANsurfer while the
qla2xxx
module is a common module.
5. Change to the
/boot
directory.
6. Back up the current RAMDISK image.
7. Build the RAMDISK image with the
mkinitrd -f
command.
8. Reboot the system to load the RAMDISK image with the driver.
Diagnostic Support for the Red Hat/SUSE OS
Diagnostic support for the HBA is available through the SANsurfer PRO graphical
user interface (GUI) utility or the SANsurfer command-line interface (CLI) utility.
These utilities support the following functions:
■
Connectivity verification
■
BIOS, FCode, EFI, and firmware version information
■
Link status, including topology, data rate, and statistics
■
Vital product data (VPD) information
■
Attached devices list
■
Option ROM, NVRAM update utilities
■
Loopback test
■
Read/Write Buffer test
...
INITRD_MODULES= ".... qla2xxx_conf qla2xxx"
...
# cp -f initrd-2.6.
kernel-version
.img initrd-2.6.
kernel-version
.img.bak
Red Hat: # mkinitrd -f initrd-2.6.
kernel-version
.img
kernel-version
SUSE: # /sbin/mk_initrd