Installing the Server Chassis
1. Remove the front door of the cabinet.
■
For an expansion cabinet, lift the door off the hinge pins.
■
For a server cabinet, pull off the front panel, then lift the door.
2. Lower the leveling pads to ensure that the cabinet cannot move.
Caution –
The next two steps require two people.
3. Turn the Ultra Enterprise 4000 chassis right side up.
4. Slide the chassis and base plate onto the rails.
5. Secure the base plate to the side rails with four 10-32 x 1/2 inch
screws, two screws at the front and two screws at the rear.
6. Connect the chassis to the power sequencer:
■
For chassis 1, disconnect the AC cable of the rack fan tray from socket
J2 and connect the AC cable to J6, then connect the Enterprise 4000
chassis to socket J2.
■
For chassis 2, use socket J7.
■
For chassis 3, use socket J11.
!
Ordering Sun Documents
SunDocs
SM
is a distribution program for technical documentation and is
available from SunExpress. You can find a full listing of available
documentation on the World Wide Web:
http://www.sun.com/sunexpress/
To order or for more information:
Telephone:
1-800-873-7869 (United States and Canada only)
Fax:
1-800-944-0661 (United States and Canada only)
Reader Comments
Your comments and suggestions are important to us. Please let us know
what you think about the Sun Enterprise 4000 Rack-Mounting Instructions,
part number 802-7249-11.
You can send detailed comments via email to
, or
send a fax to SMCC Doc Feedback at (650) 786-6443.
Sun
™
E
Rackm
Part Number: 802-7249-11
Revision A of December 1997
Copyright 1997 Sun Microsystems, Inc. All rights reserved. Use is subject to license terms. Third-party
software, including font technology, is copyrighted and licensed from Sun suppliers. Sun, Sun
Microsystems, the Sun Logo, SunDocs, and Solaris are trademarks or registered trademarks of Sun
Microsystems, Inc. in the U.S. and other countries. RESTRICTED RIGHTS: Use, duplication, or
disclosure by the U.S. Government is subject to restrictions of FAR 52.227-14(g)(2)(6/87) and FAR 52.227-
19(6/87), or DFAR 252.227-7015(b)(6/95) and DFAR 227.7202-3(a).
Copyright 1997 Sun Microsystems, Inc. Tous droits réservés. Distribué par des licences qui en
restreignent l’utilization. Le logiciel détenu par des tiers, et qui comprend la technologie relative aux
polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun. Sun, Sun
Microsystems, le logo Sun, SunDocs, et Solaris sont des marques de fabrique ou des marques déposées de
Sun Microsystems, Inc. aux Etats-Unit et dans d’autres pays.
Sun Microsystems Computer Company • 901 San Antonio Road • Palo Alto, CA 94303-4900
USA • 650-960-1300 • Fax 650 969-9131
7. Route the interface cables as appropriate and connect them to the
Enterprise 4000 chassis.
8. Reattach the upper bezel (which shows the keyswitch positions).
Start at the back edge, then swing the front down until the locking tabs
click into place.
Note –
If it is necessary to remove the bezel, the locking tabs
will be easier to reach if you remove the four screws that secure
the base plate to the side rails (shown in the previous drawing)
and pull the chassis out approximately 1 inch (2.5 cm). Secure
the base plate again afterward.
9. Replace the front door.
