Sun Microsystems 5500, Справочное руководство

Страница: 197 / 304

Appendix B Functional Description B-9
B.5.1 CPU Modules
Each CPU/ board has two sets of CPU connectors, marked PROC 0 and
PROC 1.
The order in which you fill CPU slots is not critical. However, to optimize heat
dissipation in the system:
■
Fill all PROC 0 locations on all CPU/ boards before filling any PROC 1
locations. To receive the maximum quantity of diagnostic information, fill PROC 0
on board 0.
■
After all PROC 0 locations are filled, you may begin filling the PROC 1 locations,
again starting from the lowest slot number to the highest.
B.5.2 System Master Board
The board slots are interchangeable. A system master board is selected for the
duration of POST and OBP testing, to control the testing processes. The system
master is normally the lowest-numbered slot containing a board with a functional
CPU. After the tests are finished, the board slots are again fully equivalent.
B.5.3 SIMMs
The CPU/ board has 16 slots for SIMMs, organized as two banks of eight
SIMMs.
B.5.3.1 Slot Locations
SIMMs must be installed in full banks of eight.
FIGURE B-6
shows the slot numbers
for bank 0 and bank 1.