Sun Fire X4600, Руководство по установке

Страница: 35 / 66

Connect network cables to one or more of the 10/100/1000 Gigabit Ethernet connectors labeled
NET 0, NET 1, NET 2, and NET 3 (labeled 4 in the illustration).
If you plan to interact with the system console directly, connect a mouse and a keyboard to the
USB connectors and a monitor to the video connector.
This step is optional, unless your operating system does not support headless operation.
Note –
The system console is permanently configured to a resolution of 1024 x 768 and a color
depth of 24 bits. This configuration cannot be changed. This limitation is necessary to support
video redirection by the Integrated Lights Out Manager (ILOM).
If you plan to access the ILOM over the network, connect a network cable to the 10/100 Ethernet
connector labeled NET MGT.
This step is necessary to use the full range of ILOM functionality.
If you plan to access the ILOM command-line interface using the serial management port,
connect a compatible cable to the RJ45 connector labeled SER MGT.
An adapter is shipped with the system, part number 530-3100. This a DB9-to-RJ45 adapter.
This adapter is also used with other Sun Fire systems and with Sun Netra systems. It is
compatible with the CISCO 72-3383-01 console cable.
“Communicating With the ILOM and the System Console” on page 45
▼
How to Apply Standby Power for Initial Service
Processor Configuration
Use this procedure to apply standby power to the SP before initial configuration.
Caution –
Possible equipment damage. Do not operate the server without all fans, component
heatsinks, air baffles, and the cover installed. Severe damage to server components can occur if
operated without adequate cooling mechanisms.
Caution –
A maximum of two power cords can be connected to a single branch circuit. The
remaining power cord(s) must be connected to a second branch circuit.
1
2
3
4
See Also
Cabling Diagram
35