Sun Fire X4600, Руководство по установке

Страница: 20 / 66

▼
How to Install the Express Slide Rails Onto the Server
and the Rack
Installing the slide rails and cable management arm for the first time takes approximately 45 to
60 minutes.
Note –
The express slide rail kit comes with the 4U Express Rail Rackmounting Kit card that
contains illustrations that you should refer to during this procedure. It can also be used to block
out the 4 unit (4U) space to be occupied by the server.
Attach the mounting brackets to the server.
Each mounting bracket has a flat side, which fits against the server chassis. The other side has a
pair of rims that fit into the slide rails. Each bracket has 6 key-shaped holes which fit over the
pins on the side of the server.
Note –
The last (rear-most) hole is not used.
a. Position a bracket so that the green lock levers are at the front of the server and the holes on
the bracket are over the pins on the server.
b. Hang the bracket on the pins.
The middle of the bracket will bow out slightly so that the middle hole does not engage.
c. Press down on the center of the bracket and slide forward.
All 5 pins should lock into place with an audible click.
d. Repeat the above steps with the other bracket.
Use the installation card to determine the 4U space that will be occupied by the server.
The slide rails cover the holes on the 2U space on the bottom of the 4U space that is occupied by
the server.
The installation card is designed so that it exactly covers a 4U space in the rack. The lower half
of the card is narrower than the rest, so that the holes used by the slide rails are visible.
(Optional for securing the server and slide rails for shipping) If you plan to ship the server and
slide rails in place
and you have a rack with square holes, place cage nuts in the holes at the top
and the bottom of the 2U slide rail space. It is not possible to install the cage nuts after the slide
rail is installed.
1
2
3
Slide Rail Kit
Sun Fire X4640 Server Installation Guide • December 2010, Rev A 20