Sumo DTS Series, Руководство оператора и список запасных частей

Страница: 22 / 77

22
2.3
‘RATE’ screen
This screen allows the drilling rate to be adjusted. Either kg/ha or seeds/m
2
units can be set via
the SETUP menu.
Figure 6: RATE screen - single product
Figure 7: RATE screen - dual product
NOTE: The maximum forward speed shown is the lowest for the 2 products.
2.3.1 Setting /overriding the target rate
To set the target rate , simply enter the value and press the ENTER key to confirm.
To set the target rate or manually adjust the rate for either product, first press the ENTER key to select SEED or
FERT.
The application rate on the MAIN screen is the same as that shown on the RATE screen above. If however on the rate
screen, the current rate is manually adjusted above or below the target rate, then this number will flash (on for 1 second,
off for 0.5 second).
When operating from a treatment plan, then this number should only flash if the instructed rate has been changed using the
‘+’ or ‘–‘ percentage buttons on the rate screen.
To override the target rate , use the keys. The % step is configured from the SETUP menu.
To return to the target rate, press the key.
Both products are reset to their respective target rates
Current drilling
rate
% off target
Target rate manual
override by % steps
(% step size set in
SETUP menu)
Reset to target
rate
Rate step size
Maximum forward
speed at which the
current drilling rate can
be maintained
Target
rate
% off
target
RATE_SEED_FERT.PCX
UK566-05.PCX