Installation Guide
HM2-12
Страница 1: ...Installation Guide HM2 12 ...
Страница 2: ...wiring from the switch to the valve and secure it with the cable ties provided CAUTION The valve should be mounted and connected to the wire harness before the control switch is connected to a power source This will prevent accidental shorting of the control wires to ground The valve and control are designed to operate on a 12 volt NEGATIVE GROUND or POSITIVE GROUND systems only Connection to any ...
Страница 3: ...iodically inspect those electrical connections which are exposed to the elements for signs of corrosion or other damage Replace any terminals that look as if they might fail in the field Inspect the cable connecting the switch to the valve Normal operation over time can cause a cable to move to a dangerous area If the cable is in any danger of being crushed or cut move it to a safer area and secur...
Страница 4: ...AULIC TROUBLESHOOTING If none of the circuits work and the solenoid coils are being operated with at least 11 volts measured at the coils check that the supply connections from the tractor remote to the valve are correct Check that the cylinders and or motors are connected to the valve as shown in the diagram If necessary remove the valve and connect the cylinder motor to the remote outlet to conf...
