SummaSign Pro SL D-series Cutters
User’s Manual
Operation
2-23
Weed out the rectangle. If the pattern looks like the one above, decrease the
value displayed on the LCD by pressing the
jogging key to correct the
closing lines cut.
To repeat the test, press the
key.
Press the
key to repeat the calibration test, or press the
key to interrupt
the procedure.
However, if the pattern looks like the one above, increase the value displayed
on the LCD by pressing the
jogging key to correct the closing lines cut.
To repeat the test, press the
key.
Press the
key to repeat the calibration test or press the
key to interrupt
the procedure.
A complementary test has been added to fine tune the LONG. adjustment.
Press the
1
key to perform the horizontal test; all the squares should be identical.
2.5.2
CUT BORDER
CUT BORDER is used to cut the border of the media area as defined during the
load sequence. This function can be used to verify the exact cutting area.
