Summa TRAY ONE, Руководство пользователя

Страница: 4 / 13

Setup 1-1
1 SETUP
The sheet feeder comes in two boxes. One box is with the parts that are specific for your model
of cutter. Before assembling the sheet feeder check if that box is the correct one. This box will
be referred to as box 2 in the assembly procedure below.
Put the plate from box 1 and from box 2 on
the table, they fit like a jigsaw puzzle.
Take the 4 aluminum feet holders an screw
them on the plates.
Screw a bracket on the side of the tray with
two washers and two large grip knobs. Mind
the orientation of the washers (see detail).
1.1 Assembling the sheet feeder