S 0ne
User’s Manual
Basic Operation
4-7
The setting of these options determines whether the speed and size values are displayed in
the metric measurement system or the ENG/US measurement system.
Press Menu units, then after selecting the setting, press
to confirm or
to cancel.
The panel units are chosen when the cutter is switched on for the first time.
The setting of extra parameters has already been explained in previous sections.
Sheet mode
These settings are explained in section 3.3.3.
OPOS Panelling
These settings are explained in section 3.2.3.
OPOS Origin
These settings are explained in section 3.3.1.
This option defaults all user parameters to factory default.
The Autoload option enables the user to change the vinyl unroll procedure. When autoload is
activated, the cutter will automatically unroll the vinyl, when needed. When the autoload option
is deactivated, the operator should manually unroll enough media before starting to cut.
Autoload is activated by default.
Press Autoload, then after pressing On or Off, press
to confirm or
to cancel.
ATTENTION:
Tracking is not guaranteed when autoload is set to OFF.
The Recut offset submenu is used to set or modify the distances between the jobs when making
multiple recuts. Press the Recut offset, then set it to the desired value.
Press
to confirm or
to cancel.
The default value is 40 mm.
4.5.5
Menu units
4.5.6
OPOS Parameters
4.5.7
Factory Def.
4.5.8
Autoload
4.5.9
Recut offset
