S One
User’s Manual
OPOS
3-13
1.
Power on the cutter and load media.
2.
Press the
icon.
3.
Use the arrows to put the
knife under the barcode.
4.
Press to confirm.
The cutting process starts.
•
The cutter will read the barcode and send this data to the computer.
•
The cutting software will then automatically send the correct cutting data to the cutter.
•
The cutter will start sensing the OPOS markers and cut out the job.
•
The OPOS sensor will now search whether another job was printed after the one that is
just finished and will continue to contour-cut.
This will be repeated until all contour-cut jobs on the loaded roll are cut out.
NOTE:
If the procedure has to be started from the computer (barcode server
program) then click on the start icon in the program (please refer to program
manual for more info). Then jump to step 3 in the above procedure
To ensure that OPOS is working accurately, two calibrations are necessary: the OPOS
calibration and the media calibration. The OPOS calibration is the calibration of the distance
between the knife tip and the sensor. The media calibration “teaches” the cutter the reflection
levels of the mark colour and the media colour.
NOTE:
Although the OPOS sensor has been calibrated in the factory, Summa
recommends doing a test to determine how well the factory-set parameters work
with the materials you are using. If the accuracy is not what is expected, then
perform the OPOS calibration.
D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
Set tool
under
barcode.
X 0.00 Y 1150.00
Set tool
under
barcode.
X 0.00 Y 1150.00
3.3.4.2
Initiating the barcode procedure
3.4
Calibrating OPOS
