Summa S CLASS, Руководство пользователя

Страница: 65 / 89

S One User’s Manual
OPOS 3-13
1. Power on the cutter and load the media.
2.
Tap .
3.
Use the arrows to put the
tool under the barcode.
4.
Tap to confirm.
The cutting process starts.
•
The cutter reads the barcode and sends this data to the computer.
•
The cutting software automatically sends the correct cutting data to the cutter.
•
The cutter starts registering the OPOS marks and cut the job.
•
The OPOS sensor now searches whether there is another job printed after the one just
completed and continues cutting contours.
This is repeated until all contour cutting jobs on the loaded roll have been cut.
NOTE: If the procedure is to be started from the computer (barcode server
program), click on the start icon in the program (please refer to the manual of
this program for more information). Then go to step 3 in the above procedure.
To ensure that OPOS works accurately, two calibrations must be carried out: the OPOS
calibration and the media calibration. The OPOS calibration is the calibration of the distance
between the knife tip and the sensor. The media calibration “teaches” the cutter the reflection
levels of the mark colour and the media colour.
NOTE: Although the OPOS sensor is factory calibrated, Summa recommends
performing a test to determine how well the factory-set parameters work with the
materials you are using. If the accuracy is not satisfactory, then perform the OPOS
calibration.
S1D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
Set tool
under
barcode.
X 0.00 Y 1150.00
Set tool
under
barcode.
X 0.00 Y 1150.00
3.3.4.2 Initiating the barcode procedure
3.4 Calibrating OPOS