LYNX2
LYNX2--MPO for Round Cord with 12 or 8 Individual Fibers
MPO for Round Cord with 12 or 8 Individual Fibers
Assembly
Assembly Procedure
Procedure
ETK1123092D
No twisting
No gap
Button to
start heating
Lynx heater program runs
a fan to cool the sleeve
after heating
Lightly maintaining
tension on fiber
Right side first
Then left side
Lightly maintaining tension to
prevent bending
Left side first
Then right side
Lightly maintaining tension
to prevent bending
Place fiber on
V-groove gently
If the position of the fiber
is wrong, set the fiber or
stub again.
Sleeve and Spring
should be out of
the cover.
Protection
Sleeve
Spring
(21) Set Sleeve into the heater.
(22) Confirm the position before heating.
(23) Heat Protection Sleeve.
(17) Slide the sleeve to
the holder.
(19) Pick up the spliced fiber.
No twisting
(20) Slide Protection Sleeve to
MT STUB.
No twisting
(18) Open the cover of the holder.
U
P
Grasp here
Do not touch bare fiber
(14) Pick up MT STUB and set the stub on the plastic
holder.
(15) Set stub holder on the
splicer (right side).
(16) Fusion Splice.
Push to
close
UP should be
upper side
Touch Start icon
Copyright © 2011 Sumitomo Electric Industries, LTD.
after heating
(27) Put Front Housing.
(24) Spiral & Pick up the cord.
Rotate counter-clockwise.
(25) Disassemble Rear Parts.
Rear
Stopper
Kevlar Stopper
and Boot
MT STUB Dummy CAP
(26) Slide Rear Parts and remove
Dummy Cap.
(28) Slide Kevlar Stopper. Trim the slit outer sheath.
No Thread
Get the parts/components closer
to each other and straighten the
fibers covered with the Kevlar in
the Sheath
Rotate Kevlar Stopper
with holding Kevlar on
Housing
Make sure that
the fibers with
Kevlar are not
twisted.
Kevlar
Stopper
(29) Secure Kevlar by screwing of Kevlar Stopper & Cut excess Kevlar
Boot
(30) Put Boot.
Cut Kevlar here
Complete
Spiral Tube
Approximately
middle position
Don’t go over the thread.
Cut Sheath here
Do not bend
（
Fiber Kevlar Sheath
）
Window
Ridge
Align Window and Ridge
Front Parts
Rear Stopper
Cap
Tube
