Sullair 02250160-842, Инструкция по эксплуатации

Страница: 25 / 31

Section 5
TROUBLESHOOTING
21
5. TROUBLESHOOTING
5.1 TROUBLESHOOTING INTRODUCTION
This Troubleshooting section is provided as a guide to aid in diagnosing and resolving
compressor problems when they occur. The information contained in
Table 5.1 ,
Troubleshooting Guide, has been compiled from factory experience and contains
symptoms and usual causes for the described problems. Each Service Reminder,
Warning, or Fault Message is listed with conditions of when the problem may occur, a
probable cause, and a suggested solution to the problem.
DO NOT
assume that these
are the only problems that may occur. This document cannot address every possible
adverse condition that may occur nor does it provide every solution for the potential
troubles listed. All available data concerning the trouble should be systematically
analyzed before undertaking any repairs or component replacement procedures.
Always perform a detailed visual inspection when a machine problem occurs prior to
attempting any repairs. Doing so may avoid unnecessary repair and/or additional
damage to the compressor.
Always remember to:
a. Check for loose wiring.
b. Check for damaged piping.
c. Check for parts damaged by heat or an electrical short circuit,
usually apparent by discoloration or a burnt odor.
Should your problem persist after making the recommended check, consult your nearest
Sullair Distributor or the Sullair Corporation factory Service Department.
Sections 5.2 and 5.3 portray common systematic problems that can occur
during controller operation. For a more thoroughly in-depth coverage of
machine operation troubles, consult the Troubleshooting Section in the
machine’s operator’s manual.
NOTE