Rev.06
– 03/02/2021
Pag. 27/33
Code: 71207
28.5. TROUBLESHOOTING
Problem
Possible cause - treatment
The SCOOTER does not run. When the trigger is
activated the propeller does not turn.
Open the SCOOTER, check that the batteries are
charged and that the connectors are inserted and
undamaged, then try again.
Although the battery pack has been charged and the
connectors are inserted the DPV does not run.
The control system may be damaged - must be
checked.*
The motor may be damaged - must be replaced.*
The battery pack may be damaged - must be replaced.
The speed regulator doesn’t work.
The control system may be damaged - must be
replaced.*
The SCOOTER’s running time is visibly diminished.
The batteries need to be replaced.
The battery charger is broken or does not work well -
must be replaced.
When the main switch is on, the SCOOTER runs
continuously with no chance of stopping it.
The control card is damaged - must be replaced.*
The motor is noisy.
The DPV needs to be serviced.*
Vibrations are felt when the propeller rotates.
The propeller is damaged - must be replaced.
The drive system is damaged - needs to be serviced.*
The SCOOTER floods very slowly.
Replace all the O-rings and carefully check that the
seating surfaces are not damaged.
The control trigger sticks and the SCOOTER remains
running.
Shut off the SCOOTER, try to slide the starting piston,
driven by the trigger, to get out any foreign bodies, try to
start again. If the SCOOTER continues to work, the
starting system must be verified, probably it was
damaged by a shock.
There are oil stains on the conic end of the case near
the propeller or it is visibly greasy.
The external propeller shaft seal is damaged and
requires maintenance. The second internal seal
prevents flooding but you should suspend SCOOTER
use and replace the gaskets.
* operations to be performed in an authorized SUEX service center.
TROUBLESHOOTING PROP LOCK
Problem
Solution
Great effort is needed to turn the white knob
Th knob has been damaged, it must be replaced.
Even if the shaft pin is in the correct position in the
propeller seat, the clutch skips and the dpv does not
move forward
The traction pin has been damaged and must be
replaced. The propeller hub has been damaged and
must be replaced.
Tightening the knob turns freely and does not stop the
propeller
Too much force was used to tighten the knob and it was
damaged, it must be replaced.
Tightening the screw on the knob turns it empty
The knob has been damaged and must be replaced.
* operations to be carried out in an authorized Suex service center.
Be careful when positioning the SCOOTER vertically on the conveyor, the propeller must
not touch the ground or other object.