Rev.01
– 17/02/2021
Pag. 4/16
Code: 71813
Copyrights for this manual belong exclusively to SUEX s.r.l. Reproduction of this document, in part or in whole, is
forbidden without SUEX s.r.l. written authorization.
5.
NiMH BATTERY INFORMATION
The NiMh battery consists of cells, connected in sequence, mounted on a plastic support and wired with two
connectors: one specific for connection to the battery charger and a cable, ending with a red connector, intended
for connecting the battery to the SUEX Scooter powertrain.
A new battery will only function at full capacity after four or five full charge cycles.
Extreme temperatures can affect the charging capacity of the battery.
Leaving the battery in hot or cold environments, such as in a completely closed car in summer or winter, will reduce
the capacity and life of the battery itself. Always try to keep the batteries between 15 ° C and 25 ° C. Battery
performance is significantly reduced at temperatures below 0 ° C.
Even when not in use, a fully charged battery slowly discharges due to the self-discharge phenomenon; it is
recommended to charge the batteries within 24 hours of the last use and at least once a month and, in any case,
make sure that they never completely discharge.
When the battery performance is below 20% of normal, it needs to be replaced.
Use only batteries approved by SUEX s.r.l., charging them only with the relative approved chargers.
6.
BATTERY DESCRIPTION
The BATTERY cannot be opened, it is sealed by the manufacturer and cannot be dismantled in any part. It is a
unique piece and is a spare part in its entirety.
The NiMH BATTERY is made up of 22 1.2 volt cells, connected in sequence, assembled on a plastic support, a
built in BMS electronic device manages the cells both in balancing and in protection.
Fig.1
Main battery components (fig.1) are:
•
Battery (14),
•
Charger connector cap (24),
•
Battery’s charge socket (26).
CAUTION!
This signal warns that failure to comply with what is described exposes the user
to risks that could cause permanent damage to the vehicle.
The BATTERY is marked with a serial number and with the certification code,
marked on the top cover of the battery (see Fig. under).
In case of need, the number shown must be mentioned for requests for
assistance or for the supply of spare parts.
