Black plate (507,1)
一
般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
Right-hand side
Right-hand side:
Use a screwdriver to
undo the clips on the air intake duct, then
remove the air intake duct.
2. Disconnect the electrical connector
from the bulb as pushing the tab.
Left-hand side
Right-hand side
3.
Left-hand side:
Remove the bulb
from the headlight assembly by turning it
counterclockwise.
Right-hand side:
Remove the bulb from
the headlight assembly by turning it clock-
wise.
4. Replace the bulb with new one. At this
time, use care not to touch the bulb
surface.
5. To install the bulb to the headlight
assembly, turn it to the reverse direction
until it clicks.
6. Reconnect the electrical connector.
7.
Left-hand side:
Set the washer fluid
filler pipe to the original place and secure it
by clip.
Right-hand side:
Install the air intake
duct with clips.
&
Low beam headlight (models
without LED headlights), po-
sition light (models without
LED headlights) and front
turn signal light
NOTE
.
If headlight aiming is required, con-
sult your SUBARU dealer for proper
adjustment of the headlight aim.
.
It may be difficult to replace the
bulbs. We recommend that you have
the bulbs replaced by your SUBARU
dealer if necessary.
1. Start the engine and turn the steering
wheel fully in the opposite direction of the
Maintenance and service/Replacing bulbs
11-49
–
CONTINUED
–
11
