Subaru Legacy Outback 2008, Руководство пользователя

Страница: 293 / 471

Black plate (300,1)
一 般
Model "A2440GE-A" EDITED: 2007/ 6/ 15
7-32
Starting and operating
forward driving positions into the
“
R
”
position or vice versa until
the vehicle has completely
stopped. Such shifting may
cause damage to the transmis-
sion.
.
When parking the vehicle, first
securely apply the parking brake
and then place the selector lever
in the
“
P
”
position. Avoid parking
for a long time with the selector
lever in any other position as
doing so could result in a dead
battery.
NOTE
.
When the engine coolant tempera-
ture is still low, your vehicle
’
s auto-
matic transmission will up-shift at high-
er engine speeds than when the cool-
ant temperature is sufficiently high in
order to shorten the warm-up time and
improve driveability. The gearshift tim-
ing will automatically shift to the nor-
mal timing after the engine has warmed
up.
.
Immediately after ATF (automatic
transmission fluid) is replaced, you
may feel that the automatic transmis-
sion operation is somewhat unusual.
This results from invalidation of data
which the on-board computer has
collected and stored in memory to
allow the transmission to shift at the
most appropriate times for the current
condition of your vehicle. Optimized
shifting will be restored as the vehicle
continues to be driven for a while.
&
Selector lever
: Shift possible with brake pedal de-
pressed
: Shift possible with brake pedal not
depressed
The selector lever has four positions,
“
P
”
,
“
R
”
,
“
N
”
,
“
D
”
and also has manual gate for
using manual mode.
!
P (Park)
This position is for parking the vehicle and
starting the engine.
In this position, the transmission is me-
chanically locked to prevent the vehicle
from rolling freely.
When you park the vehicle, first set the
parking brake fully, then shift into the
“
P
”
position. Do not hold the vehicle with only
the transmission.
To shift the selector lever from the
“
P
”
to
any other position, you should depress the
brake pedal fully then move the selector
lever. This prevents the vehicle from
lurching when it is started.
NOTE (3.0-liter models only)
To protect the engine while the
“
P
”
position is selected, the engine is
controlled such that the engine speed
does not become too high even if the
accelerator pedal is pressed hard.
!
R (Reverse)
This position is for backing the vehicle.
To shift from the
“
N
”
to
“
R
”
position, stop
the vehicle completely then move the
lever to the
“
R
”
position.