Subaru 2011 Outback, Руководство пользователя

Страница: 63 / 495

Black plate (66,1)
一 般
Model "A2470GE-B" EDITED: 2010/ 9/ 24
1-38
Seat, seatbelt and SRS airbags
“
Top tether anchorages
” F
1-41.
9. To remove the child restraint system,
press the release button on the seatbelt
buckle and allow the belt to retract
completely. The belt will return to the
ELR mode.
NOTE
When the child restraint system is no
longer in use, remove it and restore the
ELR mode of the retractor. That mode
is restored by allowing the seatbelt to
retract fully.
&
Installing a booster seat
1. Place the booster seat in the rear
seating position and sit the child on it. The
child should sit well back on the booster
seat.
2. Run the lap and shoulder belt through
or around the booster seat and the child
following the instructions provided by its
manufacturer.
3. Insert the tongue plate into the buckle
until you hear a click. Take care not to
twist the seatbelt.
Make sure the shoulder belt is positioned
across the center of child
’
s shoulder and
that the lap belt is positioned as low as
possible on the child
’
s hips.
4. To remove the booster seat, press the
release button on the seatbelt buckle and
allow the belt to retract.
WARNING
.
Never use a belt that is twisted or
reversed. In an accident, this can
increase the risk or severity of
injury to the child.
.
Never place the shoulder belt
under the child
’
s arm or behind
the child
’
s back. If an accident
occurs, this can increase the risk
or severity of injury to the child.
.
The seatbelt should fit snugly in
order to provide full restraint.
Loose fitting belts are not as