Subaru 2011 Outback, Руководство пользователя

Страница: 43 / 495

Black plate (46,1)
一 般
Model "A2470GE-B" EDITED: 2010/ 9/ 24
1-18
Seat, seatbelt and SRS airbags
light(s), however, will remain illuminated
continuously unless the corresponding
seatbelt(s) is fastened.
!
Other models
Your vehicle is equipped with a seatbelt
warning device at the driver
’
s seat.
Driver
’
s warning light
This device causes the seatbelt warning
light on the combination meter to illumi-
nate when the ignition switch is turned to
“
ON
”
to remind the driver to wear the
seatbelt.
If the vehicle is driven at a speed no
higher than approximately 20 km/h (12.5
mph) with the driver
’
s seatbelt not fas-
tened, the warning light will illuminate
continuously.
If the vehicle subsequently reaches a
speed of approximately 20 km/h (12.5
mph) with the driver
’
s seatbelt not fas-
tened, the warning light will start a
repeated cycle consisting of 5 seconds
of flashing followed by 1 second of steady
illumination. At the same time, a buzzer
will start a repeated cycle consisting of 5
seconds of sounding followed by a 1-
second pause. If the seatbelt is fastened
at this time, the warning light will turn off
and the buzzer will stop sounding imme-
diately.
If the driver
’
s seatbelt is still not fastened
when the 108-second period has elapsed,
the warning light will stop flashing and the
buzzer will stop sounding. The warning
light, however, will remain illuminated
continuously unless the seatbelt is fas-
tened.
&
Rear seatbelt indicator light
(Australia models)
1) Rear seat (left position)
2) Rear seat (center position)
3) Rear seat (right position)
This indicator light is located in the multi
function display. It illuminates to show only
the seating positions in which seatbelts
have not been fastened.
&
Fastening the seatbelt
WARNING
.
Never use a belt that is twisted or
reversed. In an accident, this can
increase the risk or severity of
injury.