Subaru 2004 Forester, Руководство по обслуживанию

Страница: 523 / 622

CC-5
CRUISE CONTROL SYSTEM
Actuator
2. Actuator
A: REMOVAL
CAUTION:
• Be careful not to apply excessive load to the
wire cable when adjusting and/or installing; oth-
erwise, the actuator may be deformed or dam-
aged.
• Do not bend the cable sharply with a radius
less than 100 mm (3.94 in); otherwise, cable
may bend permanently, resulting in poor per-
formance.
• When installing the cable, be careful not to
sharply bend or pinch the inner cable; other-
wise, the cable may break.
1) Disconnect the ground cable from battery.
2) Remove the clip bands from cruise control cable.
3) Loosen the nut which secures cruise control ca-
ble end to throttle cam, and then remove the cable
from throttle cam.
4) Remove the four actuator attaching bolts.
5) Remove the actuator while disconnecting the
connector.
• LHD model
• RHD model
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
ACTUATOR:
7.4 N
⋅
m (0.75 kgf-m, 5.4 ft-lb)
Cable end nut:
12 N
⋅
m (1.2 kgf-m, 8.7 ft-lb)
NOTE:
(A): Must be adjusted when the cable end outer is
fixed in place, so that gap between throttle cam and
lever is 0 — 1 mm (0 — 0.04 in), otherwise, inner
cable deflection (D) is 1 — 8 mm (0.039 — 0.315 in)
when the throttle cable is installed.
(Must be attached while the throttle cam is being
pulled by wire cable.)
(B): Must be coated evenly on the cam end inner
connection.
(C): Cover must be inserted securely, until tip of ca-
ble touches cover stopper.
CC-00009
CC-00010
CC-00070
CC-00037
(B)
(A)
(D)
(C)