25
MULTIMODE VARIABLE SLOPE BUTTERWORTH Filter
FREQ:
Cutoff frequency of the filter. [50Hz - 20kHz]
SLOPE:
Slope of the filter curve. 12/24/36/48 db/Oct
SPREAD:
Cutoff frequency spread factor of left/right channel. [-100% - +100%]
MODE
:
Filter type. Available types are [Lo-pass/Hi-pass/Bandpass/Allpass].
_______________________________
LFO
REFLEX-PRO-X provides four identical Low Frequency Oscillators as modulation source. Each LFO offers a variety of
reversible and invertible waveforms, diverse trigger and sync modes as well as phase offset. Hence the frequency could
set up to 500Hz it allows audio rate modulations.
WAVE:
Select the LFO wave either from the drop down menu by clicking into the wave display or with the left
or right arrows to step through the waves.
INVERT
:
Inverts the wave [top/bottom].
REVERSE
:
Reverses the wave [left/right].
PHASE
:
Lower fader sets the phase offset amount. [0% - 100%]
POL:
Polarity of the LFO output. Can be positive
[0 – 1], negative
[0 - -1],
or bipolar [-1 – 1]
UNIT:
Timebase of the LFO frequency. Select from HERTZ or a range of note values synced to the host
tempo.
RUN:
Running mode of the LFO. Available settings are:
“looped”
- LFO always running,
“one shot”
- LFO runs once if triggered and is restarted on every new trigger,
“latch”
- LFO runs once to the end if triggered. New triggers are ignored until end of
wave is reached.
©
2020-2021
doc version 1.2.0
