10
_______________________________
MASTER SETTINGS
WEB:
Clicking the
„STW audio“
logo launches a link to the stw-audio homepage.
KILL:
All audio buffers are cleared. Use this in emergency cases, or to abort long delay feedbacks.
MODULATION RATE:
Modulation Rate of slots main delay modulation. [0% - 100%]
MODULATION DEPTH:
Maximum overall Modulation depth of slots main delay modulation. The relative ratio to that
maximum depth can be set individually for each slot at the slot setting page. [0% - 100%]
FEEDBACK OFFSET:
Overall offset of slots feedback setting. Use this to decrease or increase the feedback amount
for all slots at once. [-50% - +50%]
DELAY TIME SCALE
:
Scale factor for all delay times [x0.5 – x2.0]
LIMITER MODE:
Enable/Disable the master limiter. The final limiter takes the sum of all four slots as input and
sends it to the 'WET' control. Modes are['Off', 'Slow 1' (Original Mode), 'Slow 2', 'Fast']
BOOST:
Input Gain of the master limiter. [0 - 36dB]
SEND:
Mutes the dry amount of the audio output. This should be the preferred mode if REFLEX-
PRO-X is used as send effect.
ATTENUATION
:
Additional attenuation of all input gains. [0dB, -3dB, -6dB, -12dB]
To keep wet/dry balance this also affects the dry output level.
NOTE: “SEND” mode and INPUT ATTENUATION are not part of the preset data but rather saved as a plugin state in
your projects.
DRY LEVEL:
Amount of dry input signal added to the plugs audio output. [0% - 100%]
WET LEVEL:
Amount of wet effect signal added to the plugs audio output. [0% - 100%]
WIDTH
:
Stereo amount of wet signal. Value < 100% = decreased stereo signal,
value > 100% = decreased mono signal. [0% - 150%]
OUTPUT GAIN:
Attenuation or gain of the plugs output signal. [-12dB - +12dB]
©
2020-2021
doc version 1.2.0
