Studer Vista 5 M3, Руководство по эксплуатации

Страница: 364 / 564

Vista 5 M3 Digital Mixing System
5-68 AutoTouchPlus
Document generated: 28.08.13 SW V4.9
5.10 Data Transition Behavior
Data Transitions In simplest terms, a Data Transition takes place whenever new data meets
old data. In more formal terms, a data transition is where Record Mix Data
transitions to Read Mix Data and vice versa. This means a transition takes
place when Read Mix Data transitions to Record data (such as at a punch in)
and when the Record Data transitions to Read Mix Data (such as a punch
out).
Note: Data Transitions are not limited to punch-in and punch-out locations.
Last Recorded Value The Last Recorded Value is always the current value of the control at the
time it is punched out. However, it should be noted that this value might have
been set well before the actual punch-out. In this case, the location of the Last
Recorded Value is earlier than the punch-out location.
By definition, the Last Record Value is a Dynamic value. However, it should
be noted that it is a singular, non-moving value.
Understanding Behaviors One of the key aspects to AutoTouchPlus is understanding where the Last
Recorded Value transitions to and from Read Mix data and how it makes the
transitions.
The ‘where’ behavior is determined in two ways:
•
Write To:
Where Record Data transitions to Read Mix Data
• Extend Back To: Where Read Data transitions to Record Data
The Last Recorded Value may be applied up to or beyond the punch-out point.
It may also be applied back to the punch in point or before. These behaviors
will be discussed below.
The ‘how’ behavior is determined by whether the Glide function is On or
Off and the Glide Options enabled.
5.10.1 Write To:
The choice of MIX PASS – Write To: function determines where the Record
Data-to-Read Mix Data transition takes place. In essence, the concept is as
follows:
‘Take the last recorded value and write it to: _____________!’
The blank can be filled in with one of following Write To: locations:
• Punch Out : Apply the last recorded value to the punch-out location
• Next Chng : Apply the Last Recorded Value to the location of the next
recorded change
• Level Match : Apply the Last Recorded Value until the it matches the
Read Mix value
• End : Apply the Last Recorded Value to the specified End Time.
These locations are also known as Write To: Functions.
Note Unlike other automation systems, the transition from Record Data to Read
Mix Data does not necessarily have to take place at the punch out location.
In fact, selecting Write To: Punch Out is the only time that both happen
simultaneously.