Studer Vista 5 M3, Руководство по эксплуатации

Страница: 354 / 564

Vista 5 M3 Digital Mixing System
5-58 AutoTouchPlus
Document generated: 28.08.13 SW V4.9
punch. This ‘TOUCH AUDITION’ mode allows the Punch-In value to be
determined by touching and moving the control to the desired position
and releasing it to return to hearing the Read mix. The control retains its
AUDITION value awaiting Punch-In while the Read mix is heard.
5.8.6 ISO (Auto Mode) Key Function
ISO (AUTO MODE)
Key The channel strip
ISO (AUTO MODE)
key is also known as ‘modifier key.’
ISO (AUTO MODE) Key Function Holding the ISO (AUTO MODE) key down temporarily reverses the state of the
TOUCH – RECORD key on a local basis. For example, if TOUCH – Re-
cord is activated in the ACU window, holding down the
ISO (AUTO MODE)
key will deactivate TOUCH – Record on that channel as long as the key
is held down. If however TOUCH – Record is not active, holding the ISO
(AUTO MODE) key will activate it for that channel.
Using the
ISO (AUTO MODE)
Key The
ISO (AUTO MODE)
key may be used as follows:
• Global TOUCH – Record Active:
- Holding the
ISO (AUTO MODE)
key will deactivate TOUCH – Record
for that channel. This will allow enabled controls to be auditioned on
a local basis without being punched-in.
- Touching an enabled control will punch it in, holding it will keep it
in RECORD. Pressing and holding the
ISO (AUTO MODE)
key before
the control is released will deactivate TOUCH – Record . When it is
released, the control will not punch-out and will stay in RECORD in
a Held state.
• Global TOUCH – Record Inactive:
- Holding the
ISO (AUTO MODE)
key will activate TOUCH – Record
for that channel. This will allow enabled controls to be punched-in on
a local basis.
- Holding the ISO (AUTO MODE) key and releasing a control that is in
RECORD will punch that control out. In this case, the control may be
touched at any time, but the
ISO (AUTO MODE)
key must be pressed at
the time of release for a punch-out to occur.