The Cylinder Trolley is designed for transporting 47kg LPG Cylinders.
The instructions stated in this manual should be adhered to at all times, failure to do so can result in serious
injury to the operator or other personnel.
Operating Instructions
Maximum safe working load – 125kg
Safety Regulations
•
Do NOT use the Cylinder Trolley unless you have read and fully understood this manual.
•
The Cylinder Trolley is built for use on level ground. When parked or not in use the Cylinder Trolley should be parked in
a safe location. Always park on as flat ground as available.
•
This product is to be used by one operator at a time and they MUST be behind the unit at all times.
•
Do NOT allow other members of staff to be in front of the unit when in use.
•
The Safe Working Load (SWL) for this unit is
125kg
and this limit should not be exceeded in any circumstance. To do so
may result in serious injury.
•
The Cylinder Trolley should be inspected at regular intervals, decided by the operator’s company, for signs of damage
or defects.
•
Ensure damaged or missing safety signs are replaced. These are available from STS.
•
The manual forces related to the use of this Cylinder Trolley are relatively low; any doubts in this should be reported to
the STS Technical Support Line.
•
If any operator is in any doubt of the correct suitability of the equipment or has any problem understanding the
instruction manual then they should contact the STS support line.
•
The mounting or installation of additional equipment which affects or enhances the performance of the equipment
requires the written permission of the manufacturer.
•
The Cylinder Trolley must be inspected at least annually or after any unusual event by a suitably competent person.
•
The Cylinder Trolley is delivered fully assembled but should be inspected for transit damage. Any damage should be
reported to STS and the equipment should be quarantined and not used.
•
If the unit is the ATEX option ensure earthing chains are securely fitted and are in contact with the ground at all times.
The manufacturers shall not be held liable in case of faults or accidents due to negligence, incapacity, installation
by unqualified personnel or improper use.
Operation and Maintenance Manual
CTS03-(Ex)
Cylinder Trolley (ATEX Optional)
The Cylinder Trolley is designed to transport gas cylinders that are 300-450mm in diameter.
•
Ensure that the cylinder you intend to load into the unit is of correct size to fit the trolley.
•
The trolley should be wheeled towards the cylinder in the vertical orientation. Fig 1.
•
The operator then slightly tilts the cylinder forward and uses the small front wheels of the trolley
to slide the footplate under the cylinder. Fig 2.
Fig no 1
Fig no 2
