Stryker SPY PHI HH9000, Руководство оператора

Страница: 50 / 112

44 4-0003045 Rev. G
CAUTION: In order for it to initialize correctly, the SPY-PHI imager should be draped, and
connected to the VPI, prior to powering on the system.
To power on the system:
1. Move the SPY-PHI System into an appropriate position for the clinical imaging
procedure.
2. Plug the VPI power cord into an AC wall outlet or isolation transformer.
After plugging in the power cable, the power indicator on the front of the VPI
above the VPI power button should illuminate amber.
▪
If the power indicator does not illuminate, check to confirm that the main
power switch (on the rear panel of the VPI) is turned to the ‘on’ position.
▪
If, after confirming that the main power switch is
in the ‘on’ position, the
indicator still does not illuminate, please consult Appendix A:
Troubleshooting.
3. Connect the draped SPY-PHI imager to VPI by plugging the camera and light
guide cables into the appropriate ports on the VPI front panel (see Figure 6).
4. Press the power button on the front panel of the VPI.
The power indicator turns green and the system enters Standby mode.
The SPY-PHI imager initializes and the Standby mode icon displays in
the top-right corner of the video image (see Figure 10).
Note: In Standby mode, video display is enabled and ventilation fans are on. Illumination
is not active and the video image on the display may be dark.