Stryker IsoTour, Руководство по обслуживанию

Страница: 20 / 44

A Acccce essss d diia ag gn no ossttiicc m mo od de e
P Prro occe ed du urre e::
1. Make sure that the support surface hoses are plugged into the pump and there is no weight on the support surface.
2. Power on the pump.
3. As the software loads, within 5 seconds of pressing the on button (Figure 2), press and hold the upper left button (Figure
3).
IsoTour
F Fiig gu urre e 2 2 –– S So offttw wa arre e llo oa ad diin ng g
V vx.x.x.xxx
F Fiig gu urre e 3 3 –– S Se errvviicce e ssccrre ee en n a an nd d vve errssiio on n
4. Press the lower left button to start the diagnostics mode.
N No otte e -- The software version is located on the service screen (Figure 3).
5. The diagnostic results should all pass with OK.
a. If diagnostic results do not pass, investigate failed area referenced in the diagnostic test results.
EN 16 2874-009-002 Rev A.1