1-28
1900-009-001 REV B
En
gli
sh
Accessories
RETRACTING PROTECTIVE TOP INSTALLATION (FA64074-BIL)
The protective top was designed to close all possible openings about the safety rails.
WARNING
•
Remove the patient from the bed before installing the accessory.
•
If the stretcher on which the protective top will be installed is equipped with the Weigh system optional), ensure
you turn it off before undertaking the installation of the top. Once done with the installation, refer to the stretcher
Operations Manual to zero the scale.
Necessary Tools:
•
9/16 in. Wrench
Prodedure: (See figure 17)
Note: Two people are necessary to install the protective top.
1. Mount the four posts into the two top plastic structures the following way: Press on the lock pin located on the top
part of the post and insert the post into one of the four slots provided on the plastic structures.
2. Ensure that the post is securely locked in place by checking that the lock pin is positioned in the slot provided on
the outer side of the plastic structure.
3. Install the four posts in the accessory bracket sockets and lock the posts in place using the four hitch pins.
WARNING
It is very important for the patient’s safety that the whole assembly is thoroughly inspected before use to ensure it is
properly and securely mounted.
Protective top
Post
Pin
Accessory bracket
Plastic structure
Lower rail
Release knobs
Figure 17