8
2236-009-101 REV B
Introduction
PRODUCT FEATURES
The Stryker Air I and II are comprised of two components:
1. Therapy Control Unit
2. Therapy Mattress System
Therapy Control Unit Features
• True low air loss with up to 100 liters of airflow per minute.
• Three modes of operation – Autofirm, Therapy and Pulsate.
• Pulsating feature that oscillates the air throughout the mattress every 30 seconds.
• Autofirm mode provides maximum air inflation designed to assist both patients and caregivers during patient transfer
and treatment.
• Patient position sensor optimizes support for seated occupants (Fowler Boost).
• Compact lightweight control unit is quiet, robust and powerful, with a reusable air filter and integrated carrying handle
for portability.
• Crisp, easy to read graphics for intuitive set up and therapy control.
• Automatic panel lock out to avoid unwanted or accidental adjustments.
• Eight therapeutic comfort control settings to maximize patient compliance and promote healing.
• Closed loop pressure sensor control system eliminates concerns of changes in mattress interface pressure due to
ambient temperature and pressure changes.
• Integrated swing out hanging brackets for fixing to most bed frames.
• Quick disconnect hose feature allows for rapid attach and CPR deflate at the control unit.
• Audible and visual alarms for power interruptions.
Therapy Mattress System (LAL Mattress and Overalay)
• Twenty (80”) or twenty one (84”) individual therapy cells help to evenly distribute the patient’s weight and maximize
pressure relief. Modular cell design mattress for ease of cleaning, re-assembly and cost effective service.
• Lower two-inch support cell provides support in the event of a power failure.
• 6.5” deep mattress therapy cells and 5” deep overlay therapy cells are constructed of highly durable, polyurethane
coated nylon to provide adequate support and prevent bottoming out for most patients within weight limit.
• Integrated low-pressure heel section provides lower interface pressures.
• Durable base tub is constructed from 100% heavy weight 1680 denier nylon with a 1.5 oz. urethane coating and
incorporates bed attachment loops for stability.
• Maximum weight capacity: Up to 500 lbs. based on model.
• CPR deflation in 30 seconds or less.
• Anti-kink, easy clean air supply hose set.
• Integrated CairRails risk management side bolsters—two inch side bolsters that inflate on both sides of the patient
along the mattress edge to provide additional support and to provide a gentle reminder to the patient that they are
near the edge of the mattress. Constructed with lower ingress/egress area.