1 of 2
Installation Instructions
02’+ RSX Sport Pedals (Manual)
SK06-HPDL-RMT01
1.
2.
Contents:
1x Gas Pedal
10x Self-tapping screws
1x Footrest
8x Bolts (6 short, 2 long)
2x Brake/Clutch Pedal
8x Locking Nuts
2x Brake/Clutch Rubber Insert 2x Drill Bit
Tools Required:
7mm socket wrench, Phillips screw driver or power drill with Phillips attachment
Disclaimer:
Please use caution and proper safety equipment when using power tools, Strut King
and its affiliates are not responsible for any injuries occurred during installation.
Place the stainless steel gas pedal cover
over the existing plastic pedal. Using the
power drill, drill 4 holes where at the
mounting locations on the pedal. Install the
two self-tapping screw onto the top
locations. The bottom two holes require
the use of the longer bolts & nuts. They
should extend out the opposite end just
enough for the nuts. The self tapping screws
can be used on the bottom two mounting
locations but the use of nuts & bolts are
highly suggested.
Remove the stock rubber pads on the
brake & clutch pedal.
