Struers Discotom-60, Инструкция по эксплуатации

Страница: 37 / 258

Discotom-60 /-65
Instruction Manual
33
3. Routine Maintenance
Accumulated dirt and swarf can restrict or cause damage to the
movement of the cutting table.
To ensure a longer lifetime for your Discotom Struers strongly
recommends daily cleaning of the cutting chamber.
Clean the cutting chamber thoroughly if the Discotom is not to be
used for a longer period of time.

Clean the cutting chamber, especially the T-slot cutting table.

Do not clean the lamp glass with alcohol. Use a damp cloth only.

Remove clamping device

Clean the cutting chamber thoroughly:
Move the cutting table forwards and backwards to access the
whole of the cutting chamber.
−
Clean along the length of the guide shafts with the flushing
gun and a brush to remove accumulated swarf.
−
Clean under the cutting table with the flushing gun and a
brush to remove accumulated swarf.

Wipe the gutter on the inside of the cutting-chamber hood and
remove accumulated swarf.

Check the level of the cooling water after 8 hours use or at least
every week.

Replace the cooling water in the Recirculation Cooling Unit at
least once a month.
Note:
For more detailed service and maintenance instructions relevant to the
cooling unit, read the Cooling Units Instruction Manual.
Daily Service
Weekly Maintenance
Cooling Unit
Monthly Maintenance
Replacing the Cooling Water