Struers Discotom-50, Инструкция по эксплуатации

Страница: 37 / 156

Discotom-50
Instruction Manual
Quick Reference Card
„
Secure the workpiece using the clamping device of your choice.
The most common is the quick-clamping device. Place the
workpiece between the clamp and the back stop.
Clamping the Workpiece
„
Push the clamp towards the workpiece and lock the quick-
clamping device with the locking handle.
„
Clamp the workpiece.
Automatic Cutting
„
Position the cut-off wheel so that it can cut the sample and lock
it in place with the black cut-off wheel locking handle on the
right of the machine.
„
Position the cutting table with FORWARDS
v
and
BACKWARDS
V
keys.
„
Carefully close the protection guard.
„
Set feed speed and Press AUTO.
„
Press START
s
to begin cutting.
„
After cutting, the cutting table automatically returns to its
start position.
„
Open the protection guard and release the clamping device.
„
Remove the workpiece.
„
Loosen the locking handle on the right hand side of the
machine, so that the cutting handle moves freely.
Manual cutting
„
Clamp the workpiece.
„
Position the cutting table under the cut-off wheel.
„
If AUTO mode is selected, de-select it.
„
Press START
s
.
„
Lower the cut-off wheel until it contacts the workpiece and
apply pressure until the sample is cut.
„
Keep the Load Bar in the green, or first part of the yellow area.
Relax pressure near the end of the cut.
„
Open the protection guard and release the clamping device.
„
Remove the workpiece.
33