Struers Discotom-50, Инструкция по эксплуатации

Страница: 17 / 156

Discotom-50
Instruction Manual
When the machine is used in AUTO mode the cut-off wheel is
stationary and the cutting table moves. In MANUAL mode the
cutting table is stationary and the operator moves the cut-off
wheel.
Starting/Stopping
the Cutting Process
„
Clamp the workpiece. Automatic Cutting
(AUTO mode)
„
Loosen the cut-off wheel locking handle situated on the right-
hand side of the cutting chamber.
„
Lower the cut-off wheel by pulling the cutting handle
downwards until the cut-off wheel is positioned ready to cut
the workpiece. Re-fasten the locking handle.
„
Press
v
FORWARDS to position the cutting table and the
workpiece just in front of the cut-off wheel.
„
Close the protection guard.
„
Set the desired feed speed and rotational speed.
„
Select AUTO mode by pressing the AUTO mode key.
„
Press START
s
; the cut-off wheel starts rotating and the
cooling water starts to flow. The cutting table moves forward
towards the cut-off wheel at the preset feed speed.
„
When the cutting table reaches the back of the cutting
chamber, the cut-off wheel automatically stops and the cutting
table returns to its start position.
„
If the machine is stopped with the STOP
o
key, the cutting
table will stay at the present position. To return the cutting
table to its start position, wait for the double beep and press
BACKWARDS
V
once.
„
If the protection guard has been opened, press and hold the
BACKWARDS key
V
to move the cutting table to its start
position.
Please Note
The cutting table will only move when AUTO mode is switched on.
13