Struers Discotom-2, Инструкция по эксплуатации

Страница: 13 / 95

Discotom-2
Instruction Manual
9

Choose a cut-off wheel of appropriate hardness for the task.
Check that the hole has the correct diameter and never use
wheels in which the hole does not fit perfectly! Fit cardboard
washers on both sides of the wheel and tighten the nut slightly.
This is usually enough to ensure that the cut-off wheel will not
slip on the spindle. If the nut is tightened too much, the wheel
may be damaged.

Be meticulous and careful when positioning and clamping the
object to be cut, preferably it should be placed so as to obtain
equal support on both sides of the cut. Check that the surface of
the object is flat against the table before tightening the quick-
clamping devices.

Check the proper functioning of the recirculation cooling unit and
the free passage of coolant from the jets of the two pipes. Make
sure to clean the sieve frequently and to replenish the system
with coolant whenever necessary.

Take the cut-off wheel slowly up to the object. Press it so hard
against the object that it literally bites into the material and not
just "drags" against it.

Keep the cut-off machine and the recirculation cooling unit clean
and in good repair.
General Rules