Stromag EZB, Инструкция по монтажу

Страница: 61 / 92

2.12 Safe handling of suspended loads
The following safety guidelines must always be observed when handling suspended loads:
• Wear personal protective equipment.
• Observe the instructions on the packing pieces.
• When transporting, only use approved lifting tool, industrial trucks and slinging equipment with sufficient
load-bearing capacity.
• Ensure that the slinging equipment is positioned correctly.
• Do not hook the slinging equipment onto components of the machine that protrude or in the eyes of attached
components.
• Never use torn or worn ropes or belts.
• Do not position ropes and belts on sharp edges, do not knot or twist them.
• Never stand under suspended loads.
2.13 Safe handling of rotating components
The following safety guidelines must always be observed when handling rotating components:
• Before commencing work, shut down the complete machine and secure it from switching back on.
• Never operate the complete machine without separating protective equipment or housing.
• After inspection and maintenance work, remount the separating protective equipment.
2.14 Safe handling with electrical hazards
2.14.1 Responsibility of the operator
• The operator must ensure that electrical units are only mounted, modified and maintained by a qualified elec-
trician or under the direction of a qualified electrician, in line with electrotechnical regulations. The operator
must further ensure that the electrical equipment and units comply with electrotechnical regulations.
• Live parts must be protected against accidental contact.
• If a defect is detected in an electrical unit, i.e. if it does not comply or no longer complies with electrotechni-
cal regulations, the operator must ensure that the defect is repaired immediately, and that the electrical unit
is not used in a defective condition if it presents an immediate danger.
• Work on electrical units is only to be performed by qualified electricians in accordance with electrotechnical
regulations. Observe all other nationally-applicable guidelines of the respective country of use.
2.14.2 Applying the five safety rules
The five safety rules must be always observed and applied when working on electrical units:
• disconnect
• secure against reconnection
• de-energise
• earth and short-circuit
• cover or shield any adjacent live parts
9
Mounting instructions Electromagnetic tooth clutch EZB • No. 590-00000 E • 10/2017