Strobel KA-ED, Инструкция по эксплуатации и ремонту

Страница: 35 / 78

31
BA_KA-ED_A22_190313_en.doc
5 Notes on repair and adjustment
C A U T I O N ! Danger of injury!
Before maintenance and repair read the safety instructions and the
operating instructions. If they are ignored, there may be serious
bodily injury.
5.1 The edge distance at stitch start and at the stitch end (Fig. 16)
The setting range at the stitch start is 10 mm to 25 mm and at the stitch end
10 mm to 50 mm.
Light barrier S8-1 sets the distance at the stitch start and S10 sets the distance at
stitch end (Fig. 16b).
If the light barrier is set closer to the needle, the distance to the edge is reduced and
vice-versa.
If the light barrier is moved to the side, then make sure the position to the
nirror/reflex foil is optimal.
(see point “5.2 Setting the light barriers (Fig. 16a + Fig. 17)
The light barrier S8-2 is functionally switched parallel to the light barrier S8-1. Light
barrier S8-2 determines the point at which sewing can begin at the earliest on the
lapel under side. This position is marked by a silver marking on the shaft in the back (1)
(Differential feed) (Fig. 16b).
In case the mechanical setting range (edge distance) at the stitch start or stitch end is
not enough, then this can be extended by changing the parameters in the
programming mode.