Strobel 327D, Руководство по эксплуатации

Страница: 18 / 38

14
BA_327D_A2_200715_en.doc
Fig. 4
3.4.2 Positions of the machine
C A U T I O N ! Danger of injury!
Danger of pulling in parts of clothing and of hair and danger of
crushing fingers and stitching fingers with needles!
When checking positions with switched-on machine keep fingers
and hands away from moving parts.
Machine with or without pneumatic:
The machine requires a needle position and depending on the sewing drive, possibly
also a reference position.
Reference position:
The reference position must be set in such a way, that the point of the needle in
direction of the insertion stitch closes with the right (inner) edge of the needle
slide plate.
Needle position (with stop in and outside the seam:
The needle position needs to be set in such a way that when the machine is at
standstill and the lifting is open the tip of the needle points in the direction of
the right stitch and the plunger, feed dog, and presser plate are at one level (the
position is located at about 8 mm after the upper needle turning point).
Notes for sewing drives which have two needle positions:
The needle position mentioned above is position 2 at the sewing drive. The
position 1 at the sewing drive should be set in such a way that when the
machine is at standstill the tip of the needle stands about
3 mm in the direction of the left stitch after the lower needle turning point.