STRIVR Pico G2, Руководство пользователя, Страница: 9 / 28

Product care & maintenance User Manual
support.strivr.com
5
Product care & maintenance
Changing controller batteries
See Controller Basics. Pico G2/4KS controllers take 2 AAA batteries; Oculus Go controllers take 1 AA battery.
After changing controller batteries, you may need to re-sync the controller.
1 2
3
Before and after cleaning and
disinfecting equipment, wash your
hands thoroughly with soap for at
least 20 seconds.
Use disinfecting wipes on
headsets, controllers, and working
surfaces (including desks, chairs,
etc) and leave to dry for 10 minutes.
Use recommended skin-friendly,
non-abrasive wipes on headset
contact areas (face pads and
straps.)
DRY MICROFIBER CLOTH LENSES
Use the dry lens micro-fiber cloth
included with your system to clean
the headset lenses as needed. Don’t
use liquid or chemical cleansers.
Starting from the center of the lens,
gently wipe the lens in a circular
motion moving outwards.
Equipment hygiene
Keep your equipment clean and disinfected with a course of two wet wipes. The steps shown here are
the minimum steps Strivr recommends and should be performed between every use of the equipment.
Your company works with Strivr to develop its own plan for VR equipment hygiene. Check your internal
documentation and always follow manufacturers’ instructions.
NOTE: Be careful not to detach the tether. If you do, open the battery compartment cover and
loop it back around the small plastic peg. When you close the battery compartment cover, be
sure the tether cord is lined up with the hole at the bottom of the cover, allowing the cover to
close properly.