Important Safety Information
1.
Compressor: Use 12 volt DC only. Make sure that your vehicle 12V power Socket is free of any ash, residue or
debris. A dirty power socket can cause the compressor and power cord to overheat. Overheating can cause
damage to your compressor/vehicle and could cause personal injury (disconnect power when not in use).
2.
This air compressor is designed to inflate car tyres, bike tyres, ATV tyres, sports equipment, air mattresses,
beach toys and other inflatables. Do not use for any other purpose other than inflating. If you do so, personal
injury can occur.
3.
When operating your compressor do not run for more than 10 minutes of continuous use. Allow compressor to
cool down for 10 minutes before re-using.
4.
After using, turn off power switch (3).
5.
The compressor is not a toy. Keep away from children at all times.
6.
Do not carry compressor by the air hose or power cord, damage may occur.
7.
Do not leave the compressor unattended while in operation.
8.
Do not over inflate. Be sure to follow the manufactures instructions for the item you are inflating.
9.
Keep the compressor away from flammable areas/liquids at all times.
10. Do not operate the compressor in wet or damp areas.
11. Operate the compressor only with the accessories that are included.
Your compressor is equipped with a Digital Tyre Pressure Gauge. The Pressure Gauge (4) can be used to
monitor air pressure level when filling your inflatable item. The Air Compressor shut’s off automatically
when the desired air pressure for the tyre or inflatable item is reached.
12V Digital Air Compressor
SWAC5
1. 12V Plug.
2. Valve/Tyre Adaptor.
3. Compressor Power Switch.
4. Pressure Gauge.
5. 3pce Adaptor Kit.
NOTE: THIS COMPRESSOR OPERATES ONLY ON 12 VOLT DC. DO NOT ATTEMPT TO OPERATE THIS
COMPRESSOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE
COMPRESSOR FROM IT'S ORIGINAL DESIGN OR PERSONAL INJURY OR BODILY HARM MAY OCCUR.
SOME VERY IMPORTANT INFORMATION ON THE OPERATION OF YOUR DIGITAL TYRE PRESSURE GAUGE
Your new Digital Tyre Pressure Gauge is capable of reading air pressure in the following formats: PSI, BAR,
KG/CM
2
and KPA.
The gauge is defaulted at the factory in the PSI mode.
If you desire to change
output mode from PSI to one of the other modes do the following:
1. Whilst in the OFF position press the (R) button for your preferred unit i.e. (PSI, KPA, BAR, KG/CM
2
).
2. Use the (+) (-) button to set the desired pressure.
3. Wait until the unit stops flashing and shows 0.00 then turn the unit on.
4. The unit will then stop automatically stop when the correct pressure is acheived.
5. When pumping, there is approximately 1 to 2 PSI difference between your tyre pressure and the
display figure due to the air hose back pressure.
6. The digital gauge display will be subject to fluctuation while pumping.
RY
n.
r
h
es
n.
ce
will
?
on.
4
3
2
1
5
2
SWAC5-Manual.qxp_Layout 1 20/03/2018 10:14 Page 2
